A set of 200 M2x3 Wrench Bolts especially designed to fix your RX Series Dynamixel servomotors.
The MX-106R is a Dynamixel servomotor, with high-level control features and very precise. It is by far the most powerful of the Dynamixel servomotors.
Need a remote to control your Robotis robotics kit? The RC-100B Remote Control offers you up to 1,023 different command combinations and 3 different communication protocols!
Horn and bearing set compatible with RX-64 (N101 type), EX-106+, MX-64 and MX-106 Dynamixel actuators.
The YM080-230-A099-RH servomotor is an all-in-one unit equipped with an integrated cycloidal reducer, specifically designed for the DYNAMIXEL DRIVE (DYD) DYD-17H-099 model.
The 4P JST Expansion Board is an extension board that allows you to add additional features to your robot.
The Dynamixel XH540-V270-R servo motor is equipped with an RS485 interface and offers a 272.5:1 reduction ratio. It’s fully programmable, and with 6 various control modes available, it is suitable for many applications and configurations.
This 150 mm 2P Cable (Battery Box) (x 4) set by Robotis allows you to establish a secure connection between your servo motors and their battery housing.
Program many Dynamixel servos directly with the U2D2 Dynamixel/PC connector, for AX/MX to pro series!
Properly fix your Dynamixel servomotors with this set of 200 M2.5x8 wrench bolts. An essential item for your toolkit!
Pack of 6 Dynamixel MX-28T servomotors
Kit containing horn, frame and bearing for Dynamixel actuators
This metal gear set is designed to last longer and resist abrasion. The gears are compatible with all servo motors in the Dynamixel X540-150 series with a TTL or RS-485 connection.
The Dynamixel shield for Arduino from Robotis can be used to control yourDynamixel servo motors using your Arduino board or an OpenCR controller.
Sabertooth 2x32 is a dual channel motor driver capable of supplying 32A to two motors–with peak currents up to 64A. It can be operated from radio control, analogue, TTL serial or USB inputs. It uses regenerative drive and will boost your robot!
This pack of 6 Dynamixel MX-28R servo motors is just the right choice for conceiving a mobile robot or any other project drawing on Dynamixel’s expertise: a servo including a gear system, a driver and a controller. The MX-28R is an efficiently designed servo with high performance actuators and communicating via an RS485 interface.
Mounting plate for Dynamixel actuators RX-64, EX-106+, MX-64 and MX-106
This gear set is designed to replace the gear parts on the X540 servo motors equipped with a reduction ratio of 270:1.
Use the M3x8 wrench bolts to fix your Dynamixel servos securely.
The Sabertooth family is back with its most ambitious motor driver: 2 x 60A for controlling robots up to 450 kg with the necessary sensitivity!
Pack of 6 Dynamixel MX-28AT actuators without any accessories
10 cables (18cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
Two frames with bolt and screws for Dynamixel MX-64 actuator.